Changes between Version 1 and Version 2 of DcPcd

Timestamp:

04/16/21 16:23:11 (4 years ago)

Author:

Christo

Comment:

--

DcPcd

@@ -14 +14 @@
 ||02.08       ||2         ||2019/02/27    ||christo.malan     ||Extend 0Pa timeOut to 60s,Ave 20 Pa readings ~10s
 ||02.09       ||2         ||2019/03/12    ||christo.malan     ||Lower gain and reset rate startup defaults.
-||02.10       ||2         ||2019/03/27    ||christo.malan     ||Slow down sample rate back to 1s /Ave 10 readings ~10s /Make sensor comms more resilient:/  reset rx count at start/  end on timeout /  wait for preamble byte
+||02.10       ||2         ||2019/03/27    ||christo.malan     ||Slow down sample rate back to 1s Ave 10 readings ~10s \\Make sensor comms more resilient:reset rx count at start end on timeout \\wait for preamble byte
 ||02.11       ||2         ||2019/04/01    ||christo.malan     ||Sync Pa samples with MM coms, Fix Poll type 9 id xx error
-||02.12       ||2         ||2019/04/10    ||christo.malan     ||PI Loop run miminum of 30 counts /  Move to manual only if in manual mode/  PI Deadband now +-1 Pa (2 Pa total)/  Force a 0 Pa reading after 3 no responce timeouts(compensate for sensor not sending 0 Pa readings)
+||02.12       ||2         ||2019/04/10    ||christo.malan     ||PI Loop run miminum of 30 counts \\Move to manual only if in manual mode \\PI Deadband now +-1 Pa (2 Pa total) \\Force a 0 Pa reading after 3 no response timeouts(compensate for sensor not sending 0 Pa readings)
 ||02.13       ||2         ||2019/10/24    ||christo.malan     ||For 0Pa, only init if not in manual
 ||02.14       ||2         ||2019/01/23    ||christo.malan     ||Add 26 sdo to change 50% Low Pa motor position, new default 100%.